| Processor/Cache |
| Processors supported |
Intel® Pentium® III Xeon™
processors 550 MHz and 500 MHz with 512 KB to 2 MB of integrated full
speed L2 cache
|
|
Intel Pentium II Xeon
processors 450 MHz, 400 MHz, and 350 MHz with 512 KB of integrated
L2 cache
|
| |
| Intel
Chipset
|
| Intel 82443GX+
(includes Intel 21150 AGP-to-PCI Bridge), Intel PIIX4E
|
| |
| System Memory |
| Memory Capacity |
Four DIMM sockets for up
to 2 GB of SDRAM (32 MB minimums |
| Memory Type |
PC/100 100 MHz SDRAM, 72-bit
ECC or 64-bit non-ECC, 168-pin gold plated DIMMs |
| DIMM Sizes |
32 MB, 64 MB, 128 MB, 256
MB, 512 MB |
| Memory Voltage |
3.3V only |
| Error Detection |
Corrects single-bit errors,
detects double-bit errors (using ECC memory) |
| |
| Expansion
Slots (all full length) |
| Description |
Six dedicated PCI slots
(bus mastering)
Two 32-bit PCI buses (one 33 MHz, one 66 MHz)
66 MHz Bus—Two slots (Compatible with 33 MHz cards)
33 MHz Bus—Four slots
One dedicated ISA slot |
| Integrated
Adaptec* SCSI Controller |
| Controller |
Adaptec* AIC*—7896
Dual Channel—one Ultra2/LVD, one Ultra-wide
Two 68-pin "wide" SCSI connectors
Max data transfer: 120MB/sec (80 + 40) |
| |
| Integrated
Intel® Network Adapter |
| Controller |
One Intel PRO/100+ Fast
Ethernet Controller (Intel 82559)
Supports 10BASE-T and 100BASE-TX, RJ45 output |
| |
|
Integrated Graphics |
| Controller |
Cirrus Logic* GD 5480 |
| Maximum Resolution |
1,280 x 1,024; 16 colors |
| Graphics memory |
2 MB 10 ns SGRAM |
| |
| Integrated
PCI/ISA IDE Xcelerator (PIIX4e) |
| IDE |
Two independent channels
for a total of four IDE devices
PIO Mode 0, PIO Mode 3, PIO Mode 4, ATA-33 and CD-ROM support |
| USB |
Two stacked USB connectors |
| |
|
Integrated Super I/O |
| Controller |
National* Super 87309 |
| Serial ports |
Two Asynch, RS-232C, 9-pin
and 10-pin |
| Parallel port |
IEEE 1284, 25-pin bidirectional |
| Floppy Controller |
1.44 MB, 2.88 MB, 3-mode
support |
| Keyboard/mouse |
PS/2, 8240A compatible |
| |
| System
BIOS |
| BIOS Type |
8 MB Flash EEPROM with Intel
Phoenix* BIOS, Multi-boot BBS (BIOS Boot Specification) 1.0 Compliant |
| Special Features |
Plug and play, IDE drive
autoconfigure, DMI 2.0, ECC/Parity support, multilingual support and
jumperless processor speed setup |
| Configuration
Utilities |
System Setup Utility (SSU)
enables easy system setup of BIOS and utilities, plug and play |
| Jumpers
and Front Panel Connectors |
| ATX Connectors |
Speaker, reset, power LEDs,
HD LED, power on/off |
| Jumpers |
Chassis intrusion; Wake
on LAN (WOL) Enable; flash configuration jumpers include: fault-resilient
booting timer, boot-block protection, boot recovery, CMOS clear, password
protect, BMC Forced Update |
| Mechanical |
| Server Board
Style |
Extended ATX, See Reference
Chassis List at: www.intel.com/go/serverbuilder
|
| Server Board
Size |
12" x 13" |
| Server
Board Power Requirements |
| +5V, +12V |
Flexible configuration through
plug-in VRMs. See www.intel.com/go/serverbuilder
for more information on power budgets and choosing VRMs. |
| +5V Standby |
0.8A maximum continuous
current |
| +12V |
5.61A maximum continuous
current |
| +3.3V |
11.05A maximum continuous
current |
| -5V |
0 |
| -12V |
0.15A maximum continuous
current |
| Server
Management Instrumentation*** |
| Failure detection |
Voltage variation, thermal,
operating-system watchdog, fan failure, hard-disk drive failure, power
supply failure, processor status, ECC memory, heat-sink fan check |
| Emergency |
Remote reset, power up/down
control, read system |
| Management Port |
event log (external modem
required) |
| Platform Event
Paging** |
Paging on 12 configurable
events (external modem required) |
| Event Logging |
Non-volatile storage to
prevent loss of logs in the event of system failure |
| Security |
Chassis intrusion (configured
through jumper), video blanking, password protection |
**BIOS/Firmware available
at www.intel.com/go/serverbuilder
following product launch.
***Full utilization of some Server Management features is dependent
on the use of an Intel server chassis. |
| Intel
Server Control (ISC), Version 1.7 |
| Managed Server |
Operating systems supported:
Windows* NT Server 3.51, 4.0
Novell Netware* 4.11, 5.0
SCO UnixWare* 7.0 |
| Management Consoles
Supported |
ISC integrates into the
leading management consoles:
Intel LANDesk® Server Manager 6.01
HP OpenView* Network Node Manager 5.02 for Windows* NT
CA TNG* Framework 2.01 for Windows* NT |
| Standalone Consoles
Supported |
Microsoft Management Console
Internet Explorer* 3.02
Netscape Navigator* 3.0 with ActiveX* snap-in |
| System Health
Monitor |
Temperature, voltage, cooling
fans, chassis intrusion, ECC memory, processor status, power supply
status, on-board NIC and SCSI
OS hang monitoring via Watchdog Timer |
| Alert Notification |
When a configured event
takes place these methods of notification are available: Network broadcast,
SNMP trap, writing into System Event log (non-volatile storage), Message
box. |
| Critical Event
Actions |
Graceful operating system
shutdown with reboot or power off at administrator's discretion
Immediate power off or reset
Immediate Generate NMI or Reset |
| Environment |
| Ambient Temperature |
|
| Operating |
0° C to +55° C |
| Non-operating/storage |
-40° C to +70° C
ambient |
| Relative Humidity |
|
| Non-operating |
95% @ 30° C non-condensing |
| Regulations |
| Safety: |
|
| U.S. & Canada |
UL/cUL 950-CSA 950-95, 3rd
Edition |
| Europe |
EN60950, 2nd Edition; IEC
950, 2nd Edition CE Mark-European Directive 73/23/EEC |
| EMI/RFI—in
a compatible host system |
| Safety Regulations: |
|
| U.S. |
FCC, CFR 47 Part 15, Class
B |
| Canada |
ICES-003, Class B |
| Europe |
Verified to EN55022 and
EN50082-1 |
| Japan/ Australia/
New Zealand |
CISPR-22/AS/NZS 3548, Class
B |
| |
|
|
top of page |
|
